=========================
LDView keyboard shortcuts
=========================

First published at 1/14/2019 on https://defkey.com/ldview-shortcuts

LDView is a 3D model viewing tool for LDraw. It is developed by Travis
Cobbs.

LDView has 51 shortcuts and we have listed all of them below.



Fly-through mode
----------------

Q                       Roll left
A                       Move left
E                       Roll right
D                       Move right
W                       Move forward
S                       Move backward
R                       Move up
F                       Move down
Up arrow / Down arrow   Pitch up / down
Left arrow / Right arrow Yaw left / right


Steps
-----

Home                    First step
End                     Last step
Page Up                 Previous step
Page Down               Next step


Program controls
----------------

Esc                     Cancel load
F1                      Help
F5                      Reload model


General
-------

Ctrl + 1                Front view
Ctrl + 2                Back view
Ctrl + 3                Left view
Ctrl + 4                Right view
Ctrl + 4                Top view
Ctrl + 5                Bottom view
Ctrl + 9                Specify lat / long
Ctrl + 0                Two-thirds view
Ctrl + Q                Exit
Ctrl + E                Export
Ctrl + R                Reset view
Ctrl + T                Model tree
Ctrl + U                Right side up
Ctrl + O                Open model
Ctrl + P                Print
Ctrl + S                Snapshot
Ctrl + F                Zoom to fit
Ctrl + G                Go to step
Ctrl + L                Parts list
Enter                   Fullscreen view
Ctrl + B                Model bounding box
Ctrl + M                MPD model selection


Misc
----

Ctrl + Shift + P        Preferences
Ctrl + Shift + E        Errors & warnings
Ctrl + Shift + S        Status bar
Ctrl + Shift + X        Examine mode
Ctrl + Shift + F        Fly-through mode
Ctrl + Shift + T        Toolbar

  When Wireframe cutaway option is enabled;

Ctrl + Right click + Move the mouse Move mouse up or down to increase or decrease the amount of the model that
is cut away

  To assign a hot key to currently selected preference set, use Preference
Sets tab > Hot Key.

Ctrl + Shift + [0 - 9]  To recall it, use the hot key you've previously set while viewing a model.


Mouse
-----

Ctrl + Left click + Move the mouse Pan the model (instead of rotating it). If you lose the model completely,
use Reset View option in the View menu
Shift + Left click      Change light direction
Ctrl + Move the mouse   (while zooming) Adjust cutaway mode instead of zooming
Ctrl + Move the mouse   (while zooming) Move the clipping plane away from the camera

  Source: Ldview help


Last modified on (UTC): Monday, November 11, 2019
Defkey © All rights reserved.