(hold and drag) Move the object currently under the cursor

Zoom-out, relative to the current cursor location

Change the view of the board (or component) in 3D so that you are looking at the board from the bottom side

Switch to routing on the corresponding routing (signal) layer (dropping a via to do so). The number can be obtained from the prefix to the layer name ([n]), on the layer tab at the bottom of the main workspace. Alternatively, the number can be acquired from the pop-up window accessed through the Ctrl + L shortcut.

Move the view of the board (or component) in 3D 500mil up

Change the view of the board (or component) in 3D so that you are looking at the board from the right edge

Extend a column selection by one page down from the current cursor position

Extend a column selection by one page up from the current cursor position

On a Sheet Entry to jump to the corresponding port on the sub-sheet referenced by that entry's parent Sheet Symbol

On a Port to jump to the corresponding sheet entry in the parent sheet symbol that references the sub-sheet on which the port resides

On a port to jump to another port with the same name, on the indicated target schematic document (only available when the Net Identifier Scope - set on the Options tab of the Project Options dialog - is set to Flat, or Global)

On a sheet symbol to descend the design hierarchy to open the child sheet referenced by that symbol

Change the view of the board (or component) in 3D so that you are looking at the board from the back side

Extend a column selection to the beginning of the current line from the current cursor position

Store the current location of the text cursor on the current document into location marker (number key)

Extend a column selection to the bottom of the current document window from the current cursor position

Extend a column selection to the end of the current line from the current cursor position

Extend a column selection to the top of the current document window from the current cursor position

(then move the mouse forward) Zoom-in, relative to the current cursor location

(then move the mouse forward) Zoom-out, relative to the current cursor location

(then move the mouse forward) Zoom-in, relative to the current cursor location

(then move the mouse forward) Zoom-out, relative to the current cursor location

Switch to the previous enabled signal layer

Extend a column selection to the beginning of the current document from the current cursor position

Extend a column selection to the end of the current document from the current cursor position

Fit document

Access the Schematic - General page of the Preferences dialog

Deselect all objects on the current sheet

Break wire

Access the Annotate dialog

Use to open the Components panel from within a Schematic document

Delete all characters from the current cursor position to the end of the current line

Fit all objects

Access the Report Manager dialog presenting a Bill of Materials for the active design project

On a vertex of a placed Wire, Line, Bus, Signal Harness or Polygon to remove that vertex

On a selected object, opens the Get X-Y Offsets dialog to move one or more currently selected objects by a specified distance in the horizontal (X) and/or vertical (Y) planes.

(hold left mouse button, then press Delete) On an end vertex of a selected polygonal-based object, use to remove that vertex

Access the Choose a snap grid size dialog in which you can set the snap grid to a user-specified value

Reset schematic designators

Reset duplicate schematic designators

Reset Component Unique IDs

Start wiring

Place Compile Mask Directive

Place Generic No ERC directive

On a selected segment of a placed Wire, Line, Bus, or Signal Harness or an edge of a placed Polygon to add a vertex at that point

Switch to the next enabled signal layer